5 pieces. knife package, Graphtec Vinyl & Paper 30º, offset 0.45mm - Ø0.9mm [NGVI3045]

Package contains: 5 pcs. plotter knives 5 pcs. springs This plotter knife fits Graphtec Cutting Pro, FC CE Series; Encad Novacut Cutting Plotter The Plotter Cutter is used for cutting in foil and paper. General Information from the Plotter Knife Product Production and Its Use. The signature production plotter knives are made of cemented carbide, which makes these extra durable. In addition to this, the knives are manufactured under the best conditions to achieve the highest quality in the market and thus a high service life with a minimum of wear. It is not possible to say how long the shelf life of a plotter has, as this depends greatly on the type of foil, cutting speed and speed. Furthermore, the blades are specially designed to be used by an electronically controlled cutting plotter for cutting in different materials. However, if your plotter knife should become blurred, it is most often due to incorrect handling of the knife. This may be due to an impact knife holder. Therefore, we recommend the following advice to increase the life of your plotter knife: • You must use the different angles for the different foils. • The knife pressure and depth must be reset after changing the knife. • The knives must always be stored in the wrapper. Never loosen. • The protective cap should be inserted after use • Do not touch the knife tip with your fingers. • Always make sure that the foil is large enough for the task, otherwise the knife will cut into the protective film on the chartplotter. • The knife pressure must be set on the chartplotter itself [especially when cutting reflex and flap films].